Friday, 20 November 2026 Independent Edition

The editorial journal of luxury watches & fine jewellery

Watches

Water Resistance Ratings, Explained (Without the Myths)

50 metres does not mean swimming. What water-resistance ratings actually certify, why they drift with age, and how to keep your watch safe in water.

3 min read

No watch specification is misunderstood more often than water resistance. The markings promise less than buyers assume, and treating them carelessly is among the most common ways a fine watch is damaged. Here is what the ratings actually mean.

Bars, atmospheres and metres

Water resistance is expressed in bars (equivalent to atmospheres, ATM) or in metres, where 10 metres nominally equals 1 bar. The critical misunderstanding: these are static pressure ratings measured in laboratory conditions, not depths you may swim to. A watch rated 3 ATM resists the pressure equivalent of 30 static metres — but the dynamic pressure of moving your arm through water, or striking the surface diving off a step, exceeds static pressure many times over.

The practical ladder

    3 ATM (30 m): splash-proof. Rain, hand-washing, accidental exposure. Not for swimming. 5 ATM (50 m): brief immersion is tolerated — showering, surface swimming for short periods. Not for deliberate water sports. 10 ATM (100 m): swimming and snorkelling are reasonable. Most modern sports watches sit here. 20 ATM (200 m) and above: serious diving territory. From here, standards require additional features (see below).

What makes it resistant at all

Three seals do the work: the crystal gasket, the caseback gasket, and the crown gasket. The crown is the weak point — it is a moving part, and if it is not fully screwed down (on screw-down models) or pushed in fully, the case is open to water at any rating. Chronograph pushers on diving watches are engineered accordingly; on dress chronographs, pressing a pusher underwater is an invitation to moisture ingress.

ISO 6425: the diver’s standard

Watches marketed as dive watches should conform to ISO 6425, which requires among other things: resistance to 100 m minimum, unidirectional rotating bezel, luminous marker visible at 25 cm in darkness, and resistance to thermal shock and salt water. A watch with “Diver’s” on the dial should meet this; a watch with merely a high ATM figure may not.

Age degrades every rating

Gaskets are rubber. Rubber hardens, cracks and shrinks — typically over years, faster with heat and chlorine exposure. A fifteen-year-old watch marked 10 ATM may no longer hold 1 ATM. This is why reputable service includes pressure testing, and why a vintage watch’s rating should be treated as historical information rather than a current guarantee. If water exposure matters to you, have the watch tested and resealed before the season starts, not after the damage.

Rules of thumb

    Never operate the crown or pushers underwater. Always screw down or seat the crown fully before any water contact. Rinse a salt-exposed watch in fresh water (only if rated for swimming) and dry it. Assume vintage ratings have decayed; test before trusting. Remember heat: saunas and hot showers attack gaskets far faster than cold water.

Water resistance is a maintenance state, not a permanent property. Treated that way, the rating on the dial becomes what it should be: a useful, honest number.

Published in Watches
01
Newsletter

The Sunday <em>Edit</em>

One considered letter each Sunday — the week in watches, gems and craft, curated by our editors.